Front Loading Tumbler

Front Loading Tumbler

The key to wetblasting is that the finish is produced through flow of water borne abrasive and not by impact. This creates a finer finish due to the lubrication and flushing action of the water during the blasting process.

Media impregnation into the component is avoided and the life of the blast media is extended.

The machine operates using a PLC controller. This controller is programmed with the various functions needed to produce a consistent finish on batches of components. Various drum designs are available as well as rinse options.

This is an excellent entry-level wet blasting machine.

Media impregnation into the component is avoided and the life of the blast media is extended.

Octagonal Drum

The components to be cleaned are placed inside the octagonal drum (sometimes circular with paddles) and slowly rotated while simultaneously being blasted

Degreasing

A detergent may be added to the water/slurry where a light degreasing/removal of oils may be required – The benefit of the wet blasting system is that components can be placed in the machine without the need of degreasing prior

Blasting Slurry

The blasting slurry can be heated to 30-40 degrees if necessary and this temperature will initially warm the components being blasted

Blasting Slurry

The blasting slurry can be heated to 30-40 degrees if necessary and this temperature will initially warm the components being blasted

Blast Cycle

At the end of the blast cycle the PLC controls the draining of the solution and the rinse cycle begins

Features

Fully stainless steel construction
Quick release highly efficient submersible polyurethane pump
PLC controller for the following:
- Blast cycle times
- Rinse cycle times
- Water temperatures
- Drain valve opening & closing
- Windscreen wiper & rinse

Optional extras

- 1 or 2 stage rinse
- Unload facilities
- Additional blast guns
- Hot rinse
- Demineralized rinse
- Cycle indicator
- Touch screen controls

Inquire About This Machine